OMEG-ART – Floor Varnish with Hardener – CARVER

264.95 $279.95 $X

Floor Varnish with Hardener having a Very High Resistance.

OMEG-ART by CARVER is a two-component, water-based polyurethane varnish for floors and other wood or cork surfaces exposed to heavy traffic. OMEG-ART does not change the natural colour of the wood and offers excellent resistance to abrasion and scratches, as well as high resistance to domestic chemical agents.

This floor varnish is particularly recommended for finishing floors in sports halls, as it fully meets the adhesion requirements of the EN 13036-4 regulation. OMEG-ART nature effect is specially designed to give an untreated wood look to light wood species (oak, coniferous, chestnut, maple, etc.) while maintaining the protection of the varnishing treatments.

  • High resistance
  • Does not alter the colour of the wood
  • Suitable for residential, commercial and industrial environments
  • Easy to mix and apply


  • Sand the surface, removing all traces of oil, wax or varnish. After sanding (use 100-120 grit), remove the dust produced with a hoover and an antistatic cloth.
  • It is advisable to acclimatise and apply the varnish at a room temperature between 15°C and 35°C with a relative humidity between 35 and 75%.


  • The application can be done with a brush, roller, spray gun or in a spray booth.
  • Shake OMEG-ART component 1 (varnish) well and add IDRO2 (hardener) to the varnish in the exact proportion (10%) and mix well, scraping the edge of the container to obtain a homogeneous mixture.
  • Wait 15-20 minutes before applying.
  • In order not to alter the colour of the light wood: apply 2 to 3 coats of the catalysed varnish with a brush or roller, sanding with 150-180 grit abrasives between one coat and the next.


Directly on the wood in 3 coats.

2 coats only over 1 coat of Prim’Sealer or Prim’Gold.


4 hours


After each sanding, carefully remove the dust. Also, observe the prescribed sanding and covering times.

Recoating without sanding, never exceed 6 hours between coats.

The surface can be walked on with care: after 24 hours.

Optimum physical resistance: after 6-8 days.




10-12 m2 / Litre

107.64 – 129 ft2 / Litre


5 L


Satin (35% gloss)

Matt (15% gloss)

Natural effect (6% gloss)


To clean the varnished floor, remove dust with an antistatic cloth. If necessary, use a hoover with a non-rotating brush with natural fibre bristles. Wash with a soft mop moistened with a diluted solution of DETER PARQUET.


In the matt version, the varnish tends to shine if applied in a very thin layer. To minimize this problem, it is suggested to apply the product with a maximum coverage of 10 to 12 m2/litre (107.64 -129 ft2).

Before treating tropical or dark woods in general, it is advisable to carry out a preliminary test to avoid undesired curves.

Do not dispose of any residues in the environment or sewage system.

The product can be stored for 12 months in a cool, dry place and in its original unopened packaging.

Fear frost !

Fiche technique 

Fiche de sécurité – OMEG-ART

Fiche de sécurité – IDRO2